Take spinning wheel as an example. The specific methods are as follows: prepare materials: spinning wheel, fishing line, scissors.
1. First put the fishing line on the table and then fold it in half, as shown in the following figure

2. After folding the fishing line in half, bend the end of the line back, as shown in the figure below.

3. Thread the thread into the circle, as shown in the figure below, and then repeat the previous step, winding the thread for 3~4 turns.

4. After 3~4 circles of winding, pull the fishing line to both sides, tighten the fishing line, and bind it into a looper coil.

5. After looper coil is bound, use scissors to cut off excess thread ends.

6. Take out the spinning wheel, open the thread cup holder, and put the loop into the thread cup holder.